Back Of The Switch - HP J3245A Installation And Configuration Manual

Switch Reference

Back of the Switch

Back of the Switch
N o t e
If you use the optional redundant power supply (RPS) do not use the
power cord that plugs into the power cord receptacle (figure D-5).
Power Cord
Receptacle
RPS Connector
Figure D-5. Back Panel of the Switch 800T
Power Connector
The Switch 800T does not have a power switch; it is powered on when the
power cord is plugged into the power connector. The switch's power supply
automatically adjusts to any AC power source between 90 and 240 volts. There
are no voltage or frequency range settings needed.
The HP J2962 AdvanceStack Redundant Power Supply (RPS)
The HP J2962 AdvanceStack Redundant Power Supply is an optional power
supply you can connect to your Switch 800T instead of the switch's own power
cord to provide a redundant power source. That is, the RPS replaces the
switch's single AC power supply and single DC power converter with a dual
AC power supply and dual DC power converter. For more on using the
optional RPS with the Switch 800T, refer to "Connect a Power Supply" on page
1-16, and to the documentation provided with the RPS.
D-7