Trap Receivers Features - HP J3245A Installation And Configuration Manual

Configuring the Switch
Configurable Features

Trap Receivers Features

Enables you to configure up to ten IP and/or IPX management stations (trap
receivers) to receive SNMP trap packets sent from the switch. Trap packets
describe specific event types. (These events are the same as the log messages
displayed in the event log.) The protocol, address, and community define
which management stations receive the traps. An authentication trap is sent
and the Security LED on the front panel of the switch begins flashing if a
management station attempts an unauthorized access. (The ClearLED
command turns off the Security LED—page 6-6.) Check the event log to help
determine why the authentication trap was sent. (Refer to chapter 4 for
information on the event log.)
Figure 3-10. The Trap Receivers Configuration Screen (Default Values)
3-15