Install Add-In Transceivers (Optional) - HP J3245A Installation And Configuration Manual

1. Install Add-In Transceivers (Optional)

The Switch 800T is shipped with four HP J3192B AdvanceStack 100Base-TX
Twisted-Pair Transceiver Modules already installed. (The switch does not
support use of the "A" version—HP J3192A—of this transceiver.) Additional
twisted-pair (UTP) or fiber transceivers must be purchased separately. (You
need a minimum of one transceiver installed to connect the switch to your
network, and one additional transceiver installed for each connection to a
server, hub, switch, or other device.) The Switch 800T is designed to operate
with either of the following two transceivers:
C a u t i o n
To avoid damage to circuitry in the Switch 800T and transceivers,
always have the power to the Switch 800T turned off while a trans-
ceiver is being installed or removed.
For proper cooling and for reduction of electromagnetic emissions, ensure
that a slot cover (provided with your Switch 800T) is installed on any unused
transceiver slot.
Figure 1-1. Switch 800T with Factory-Installed HP J3192B 100Base-TX (UTP)
HP J3192B AdvanceStack 100Base-TX Twisted-Pair Transceiver Module
HP J3193B AdvanceStack 100Base-FX Fiber-Optic Transceiver Module
Factory-Installed
100Base-TX (UTP)
Transceivers
Transceivers
Installation
1. Install Add-In Transceivers (Optional)
Slot Covers on Unused
Transceiver Slots
1-3