HP J3245A Installation And Configuration Manual page 140

Advanced Concepts
Automatic Broadcast Control (ABC)
2.
3.
N o t e
The rest of this procedure assumes that VLANs are not configured. If you have
VLANs configured on your switch, you can still use this procedure. The screen
layout will be different than shown here, but the parameters are the same.
4.
Figure 7-19. The Default ABC Screen (No VLANs Configured)
5.
6.
7-34
Select Automatic Broadcast Control (ABC) and press [Enter].
If no VLANs are configured, go to step 4 . If VLANs are configured, press
Edit, then select the VLAN in which you want to configure ABC.
Press [E] (for Edit).
Use the Space bar to enable ABC. Select one of these options:
• IP_IPX: Enables ABC for both the IP and IPX protocols.
• IP: Enables ABC only for the IP protocol.
• IPX: Enables ABC only for the IPX protocol.
• Disabled
If you want broadcast control disabled for IP RIP and/or IPX RIP and SAP
broadcasts, leave the remaining parameters set to No and go to step 7.
If you do want broadcast control for RIP or SAP broadcasts, press an
Note: This is the screen
layout when no VLANs are
configured. The screen has
a different appearance if
VLANs are configured.