Installation; Rack Mounting Instructions; Figure 1- Mount Rackmux To Rack - NTI RACKMUX-T15-CS16/8 Installation And Operation Maintenance

NTI RACK MOUNT CONSOLE TERMINAL WITH CONSOLE SWITCH

1. INSTALLATION

1.1 Rack Mounting Instructions

The RACKMUX was designed to be mounted to a rack and includes mounting flanges to make attachment easy.
1. Determine the mounting height in the rack for the drawer.
LCD display. Mark holes in each of the 4 corner cabinet rails at points all level with each other.
2. Secure the rear brackets to the rear rack cabinet rails at the holes marked in step 1 using #10-32x3/4" screws and cage nuts
(supplied). Be sure to tighten the screws securely.
3. Lift the keyboard into position and line the studs on the left and right sides up with the slotted openings in the rear bracket.
Apply the nuts (supplied) to the studs but do not tighten the nuts yet.
FYI: There are 5 mounting studs provided on each side of the RACKMUX. Depending on the depth of the rack and
distance apart of the cabinet rails, the position of the rear bracket may make all 5 studs available for use.
apply the 2 nuts to the studs furthest apart from each other on each side.
4. Slide the drawer in until the top holes in the front bracket flanges line up with the holes marked in step 1. Secure the front
brackets on the drawer to the front cabinet rails using #10-32x3/4" screws and cage nuts (supplied). Be sure to tighten the
screws securely. Then tighten the nuts applied in step 3.
Front Cabinet Front Cabinet Front Cabinet Front Cabinet
Rail Rail Rail Rail
Front bracket Front bracket Front bracket Front bracket
flange on drawer flange on drawer flange on drawer flange on drawer
Secure bracket
to rail using two
screws and nuts
(supplied)
Stud on drawer Stud on drawer Stud on drawer Stud on drawer
Rear bracket overlapping Rear bracket overlapping Rear bracket overlapping Rear bracket overlapping
Drawer Drawer Drawer Drawer
drawer drawer drawer drawer
Apply nuts (supplied) to studs and Apply nuts (supplied) to studs and Apply nuts (supplied) to studs and Apply nuts (supplied) to studs and
secure rear brackets to drawer. secure rear brackets to drawer. secure rear brackets to drawer. secure rear brackets to drawer.

Figure 1- Mount RACKMUX to rack

It should be a height comfortable to use the keyboard and see the
Rear Cabinet Rear Cabinet Rear Cabinet Rear Cabinet
(Rear edge (Rear edge (Rear edge (Rear edge
of drawer) of drawer) of drawer) of drawer)
5
In this case,
Rail Rail Rail Rail
Rear bracket Rear bracket Rear bracket Rear bracket
flange flange flange flange
Secure bracket
to rail using two
screws and nuts
(supplied)