Installation; Rack Mounting Instructions; Figure 1- Mount Rackmux To A Standard Rack; Figure 2- Position Rackmux With Clearance To Open - NTI RACKMUX-V15 Installation And Operation Manual

NTI RACKMUX-V15/17 RACKMOUNT LCD MONITOR WITH KEYBOARD AND MOUSE

INSTALLATION

Rack Mounting Instructions

The RACKMUX was designed to be mounted to a rack and includes mounting flanges to make attachment easy.
1. Determine the mounting height in the rack for the drawer.
LCD display. Mark holes in each of the 4 corner cabinet rails at points all level with each other.
2. Secure the rear brackets to the rear rack cabinet rails. Apply the top screws (supplied) for each bracket to the holes marked in
step 1.
3. Lift the keyboard into position and line the studs on the left and right sides up with the slotted openings in the rear bracket.
Apply the nuts (supplied) to the studs but do not tighten the nuts yet.
FYI: There are 4 mounting studs provided on each side of the RACKMUX. Depending on the depth of the rack and
distance apart of the cabinet rails, the position of the rear bracket may make all 4 studs available for use.
apply the 2 nuts to the studs furthest apart from each other on each side.
4. Slide the drawer in until the top holes in the front bracket flanges line up with the holes marked in step 1. Secure the front
brackets on the drawer to the front cabinet rails with two screws per bracket. Be sure to tighten the screws securely. Then
tighten the nuts applied in step 3.
5. Apply one more screw to each of the rear brackets to finish.
Front Cabinet
Front bracket
flange on drawer
Secure bracket
to rail using two
screws and nuts
(supplied)
Note: To provide sufficient room for the LCD monitor to be opened to a proper viewing angle (a minimum 90 degree
position from the keyboard), ensure that all devices mounted above the RACKMUX extend no more than 1.75" from the
rack frame. (See Fig. 2)
Rail
Stud on drawer
Rear bracket overlapping
Drawer
drawer
Apply nuts (supplied) to studs and
secure rear brackets to drawer.

Figure 1- Mount RACKMUX to a standard rack

"X" must be
less than 1.75"
for LCD to open
to full 90
90
Side View of RACKMUX

Figure 2- Position RACKMUX with clearance to open

It should be a height comfortable to use the keyboard and see the
Rear Cabinet
(Rear edge
of drawer)
Server mounted
X above RACKMUX
in the same rack
3
In this case,
Rail
Rear bracket
flange
Secure bracket
to rail using two
screws and nuts
(supplied)