Rackmux Single-Person Installation; Figure 1- Adjustable Rail Assemblies - NTI RACKMUX-V17-N-8USBHDU Installation Manual

NTI RACKMUX-V17-N-8USBHD-IP RACKMOUNT DRAWER WITH USB KVM SWITCH AND KVM ON IP

RACKMUX SINGLE-PERSON INSTALLATION

Your NTI RACKMUX Drawer was designed for easy installation by one person with a minimum of tools and effort. Follow the
simple steps below to quickly install your RACKMUX Drawer.
If you would like to see a video of this installation, click on this
1. Locate and unpack the hardware bag.
model (see the manual that accompanied your RACKMUX drawer), including the following hardware unique to the Single-Person
hardware installation:

10- #10-32 cage nut

2- #10-32 x 1/2" flat-head machine screw

8- #10-32 x 3/4" pan-head machine screw
To install the rails you will need only a tape measure and Phillips screwdriver.
2. Unpack the left and right rail assemblies. Each are labeled "Right Front" and "Left Front" to indicate their intended position and
orientation. Extend each rail assembly to the dimension required for your rack. Rail assemblies are adjustable to fit within a rack
between 24" and 40" in depth.
Labeled
XXXXX
Your hardware bag will include all items necessary to install the specific RACKMUX
Rail assemblies are adjustable in length from 24" to 40".

Figure 1- Adjustable rail assemblies

link to go to a webpage where an installation video can be found.
2