Confirm The Ip Address, Test The Audio, And Check The Volume - CyberData 11021 Operation Manual

2.2.3.2 Link LED
●
●

2.2.4 Confirm the IP Address, Test the Audio, and Check the Volume

2.2.4.1 Reset Test Function Management (RTFM) Switch
When the speaker is operational and linked to the network, use the Reset Test Function
Management (RTFM) switch
speaker's IP Address, test that the audio is working, and check the volume.
To announce a speaker's current IP address:
1. Press and release the RTFM switch within a five second window.
2. When you hear the IP address announcement, check the speaker volume.
Note
Note
Operations Guide
The Link LED is illuminated when the network link to the speaker is established.
The Link LED blinks to indicate network traffic.
The speaker will use DHCP to obtain the new IP address (DHCP-assigned address or
default to 10.10.10.10 if a DHCP server is not present).
Pressing and holding the RTFM switch for longer than five seconds will restore the speaker
to the factory default settings.
(Figure 2-12) on the speaker face to announce and confirm the
Figure 2-12. RTFM Switch
930274C
Installing the VoIP V2 Speaker
Device Configuration
RTFM switch
CyberData Corporation
15