Power Up Mode; Common Address; Memory Management; Copy A Block - Barco R9002411 Owner's Manual

Service Mode

Power up Mode

When switched on from the Power switch, the projector can start up in 'Operating mode' or 'Stand-by mode'.
Operating mode : The projector starts up and displays the image.
Standby mode : The projector starts up in Standby and waits until the Standby key or a digit key is pressed.
'
To change the powerup mode, select Power up using the arrow keys and
then press ENTER to toggle between Operating and Standby.
EXIT returns to SERVICE menu.

Common Address

Common Address is an address that all projectors respond to. The toggling of
this control sets the address to 0 or 1.

Memory Management

Highlight MEMORY MANAGEMENT using the
arrow keys then press ENTER to display the
MEMORY MANAGEMENT menu.
Within the memory management menu, the
following items can be executed :

- copy a block

- delete a block
- delete all blocks
- all settings to mid position
- R & B convergence to mid
7 - 4 ___________________________________________________________________________ R5976101.02 BARCO CINE5 310102
SERVICE MODE
PROJECTOR SETUP
MEMORY MANAGEMENT
COMMON SETTINGS
I2C DIAGNOSTICS
or
Select with
then <ENTER>
<EXIT> to return
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
Standby
POWERUP MODE :
COMMON ADDRESS : 0
or
Select with
then <ENTER>
<EXIT> to return
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
Standby
POWERUP MODE :
COMMON ADDRESS : 0
or
Select with
then <ENTER>
<EXIT> to return
MEMORY MANAGEMENT
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
ALL SETTINGS TO MID POS
R & B CONVERGENCE MID
or
Select with
then <ENTER>
<EXIT> to return