Wiring Control Circuit Terminals; Wire Sizes - Omron VARISPEED F7 User Manual

Wiring Control Circuit Terminals

Wire Sizes

For remote operation using analog signals, keep the control line length between the Analog Operator or oper-
ation signals and the Inverter to 50 m or less, and separate the lines from main power lines or other control cir-
cuits to reduce induction from peripheral devices.
When setting frequencies from an external frequency source (and not from a Digital Operator), use shielded
twisted-pair wires and ground the shield for the largest area of contact between shield and ground.
The terminal numbers and the appropriate wire sizes are shown in
Table 2.7 Terminal Numbers and Wire Sizes (Same for all Models)
Terminals
FM, AC, AM, SC, SP,
SN, A1, A2, +V, –V, S1,
S2, S3, S4, S5, S6, S7,
*1 *1
BB , BB1 ,
MA, MB, MC, M1, M2,
M3, M4, M5, M6
MP, RP, R+, R-, S+, S-,
IG
E (G)
* 1. Terminals BB and BB1 are only available in the Inverter version with Safety.
* 2. Use shielded twisted-pair cables to input an external frequency reference.
* 3. We recommend using straight solderless terminal on signal lines to simplify wiring and improve reliability.
Straight Solderless Terminals for Signal Lines
Models and sizes of straight solderless terminal are shown in the following table.
2
Wire Size mm (AWG)
0.25 (24)
0.5 (20)
0.75 (18)
1.25 (16)
2 (14)
Possible
Termi- Tightening
Wire Sizes
nal Torque
2
Screws (N•m)
mm
Single wire
0.5 to 2.5
Phoenix
Stranded
0.5 to 0.6
type
wire:
0.5 to 1.5
(26 to 14)
0.5 to 2.5
M3.5 0.8 to 1.0
(20 to 14)
Table 2.8 Straight Solderless Terminal Sizes
Model d1
AI 0.25 - 8YE 0.8
AI 0.5 - 8WH 1.1
AI 0.75 - 8GY 1.3
AI 1.5 - 8BK 1.8
AI 2.5 - 8BU 2.3
Fig 2.10 Straight Solderless Terminal Sizes
Table 2.7.
Recom-
mended
Wire Size
(AWG)
2
mm (AWG)
*2
:
0.75
• Shielded, twisted-pair wire
(18)
• Shielded, polyethylene-cov-
ered, vinyl sheath cable
1
(12)
d2 L
2 12.5
2.5 14
2.8 14
3.4 14
4.2 14
Wire Type
*3
Manufacturer
Phoenix Contact
2-
2
21