Switching Modes - Omron VARISPEED F7 User Manual

Switching Modes

The mode selection display will appear when the MENU key is pressed. Press the MENU key from the mode
selection display to switch through the modes in sequence.
Press the DATA/ENTER key to enter a mode and to switch from a monitor display to the setting display.
Display at Startup
Rdy
-DRIVE-
Frequency Ref
U1- 01=50.00Hz
U1-02=50.00Hz
U1-03=10.05A
Mode Selection
MENU
Display
-DRIVE-
** Main Menu **
Operation
MENU
-QUICK-
** Main Menu **
Quick Setting
MENU
-ADV-
** Main Menu **
Programming
MENU
-VERIFY-
** Main Menu **
Modified Consts
MENU
-A.TUNE-
** Main Menu **
Auto-Tuning
To run the inverter after viewing/changing parameters press the MENU key and the DATA/ENTER
key in sequence to enter the Drive mode. A Run command is not accepted as long as the drive is in
any other mode.
IMPORTANT
Monitor Display
-DRIVE- Rdy
Monitor
RESET
U1 - 01=50.00Hz
U1-02=50.00Hz
U1-03=10.05A
ESC ESC
-QUICK-
Control Method
A1-02=2 *2*
Open Loop Vector
ESC
-ADV-
RESET
Initialization
A1 - 00=1
Select Language
ESC ESC
-VERIFY-
None Modified
ESC
-A.TUNE-
Tuning Mode Sel
T1- 01=0 1 *0*
Standard Tuning
"0"
ESC
Fig 3.3 Mode Transitions
Setting Display
-DRIVE- Rdy -DRIVE-
Frequency Ref Frequency Ref
U1- 01=50.00Hz
U1- 01=050.00Hz
U1-02=50.00Hz (0.00 ~ 50.00)
U1-03=10.05A
ESC
-QUICK-
Control Method
Open Loop Vector
ESC
-ADV- -ADV-
Select Language
Select Language
A1- 00 =0
*1*
English
ESC
The constant number will be displayed if a
constant has been changed. Press the
DATA/ENTER key to enable the change.
-A.TUNE-
Tuning Mode Sel
ESC
Rdy
" 00.00Hz "
A1-02= 2 *2*
A1- 00= 0 *1*
English
T1- 01= 0 *0*
Standard Tuning
"0"
3-
3
5