Run Command Input Methods; Selecting The Run Command Source - Omron VARISPEED F7 User Manual

Run Command Input Methods

Selecting the Run Command Source

Set parameter b1-02 to select the source for the run command.
Related Parameters
Parameter
No.
b1-02
Performing Operations Using the Digital Operator
When b1-02 is set to 0, you can perform Inverter operations using the Digital Operator keys (RUN, STOP, and
FWD/REV). For details on the Digital Operator, refer to
Performing Operations Using Control Circuit Terminals
When b1-02 is set to 1, Inverter operations can be performed using the control circuit terminals.
Performing Operations Using a 2-wire Control
The factory setting is set to a 2-wire control. When the control circuit terminal S1 is set to ON, forward opera-
tion will be performed, and when S1 is turned OFF, the Inverter will stop. In the same way, when the control
circuit terminal S2 is set to ON, reverse operation will be performed, and when S2 is turned OFF, the Inverter
will stop.
6
12
6-
Name
RUN command source selection
Forward/Stop
Reverse/Stop
SN
Fig 6.12 2-Wire Control Wiring Example with Positive Logic
Change
Factory during
Setting Opera-
V/f
tion
1 No Q
page 3-1, Digital Operator and
Inverter
Digital input neutral
Control Methods
Open Closed
V/f with
Loop Loop
PG
Vector Vector
Q Q Q
Modes.