Print Style Setting - Sharp MX-M350U Operation Manual

ADMINISTRATOR SETTINGS
Duplex reception setting
You can use this setting to select whether received
documents are printed on both sides of the paper.
Normally this setting is turned off. If turned on,
received documents will be printed on both sides of
the paper whenever the received document consists
of two or more pages of the same paper size.

Print style setting

This setting determines the selection condition for
paper when printing received documents. Select
one of the three conditions below. AUTO SIZE
SELECT is normally selected.
● PRINT ACTUAL SIZE CUT OFF DISABLED
Each received image is printed at actual size
without splitting the image onto multiple sheets of
paper. If there is no paper available that is the same
size as the image or greater, the entire document is
temporarily stored in memory.
● PRINT ACTUAL SIZE CUT OFF ENABLED
Each received image is printed at actual size. If
necessary, the image is split onto multiple sheets of
paper.
● AUTO SIZE SELECT
Each received image is printed at actual size when
possible. When not possible, the image is
automatically reduced before printing.
Set address for data forwarding
When a problem prevents the machine from printing a
received Internet-Fax, the transfer function can be used
to forward the received Internet-Fax to another machine.
Use this setting to program the e-mail address of the
destination machine. Only one e-mail address can be
programmed (maximum of 64 digits).
Touch the [FORWARDING TO] key and input the
address.
POP3 communication timeout setting
This setting determines the time the machine waits
before cancelling data reception when the mail
(POP3) server does not respond. The time can be
set from 30 to 300 seconds in 30 second
increments. The default setting is 60 seconds.
SYSTEM SETTINGS
POP3 COMMUNICATION TIMEOUT SETTING
SET THE TIME FOR STOPPING DATA RECEIVE OPERATION IN THE CASE OF NO RESPONSE
FROM MAIL SERVER. (30 - 300 sec.)
6
Set the time by touching the
then touch the [OK] key.
*1 On the MX-M350N/450N, or on a model with the network expansion kit (with hard drive) installed
*2 Without the network expansion kit (with hard drive)
I-Fax output tray setting
Anti junk mail/domain name setting
1
SYSTEM SETTINGS
ANTI JUNK MAIL/DOMAIN NAME SETTING
2
3
1
2
and keys and
8-9
This setting is used to select the output tray for
received Internet-Faxes. The trays that can be
selected will vary depending on what peripheral
devices have been installed.
This setting is used to enter addresses from which
you wish to block I-Fax reception. Up to 50*
addresses can be entered.
This setting is normally disabled.
To block reception from the entered addresses,
touch the [REJECT RECEPTION] key.
To allow reception from the entered addresses,
touch the [ALLOW RECEPTION] key.
To ignore entered addresses and allow reception
from any addresses, touch the [ALL INVALID] key.
Entering anti junk mail/domain name
Touch the [ENTER] key.
The address entry screen appears.
ANTI JUNK MAIL SETTING
ENTER
ALLOW RECEPTION
DELETE
REJECT RECEPTION
Enter the the e-mail address or domain name.
Up to 64 digits can be entered.
If the first letter is not "@", the string is regarded as
an e-mail address. If the first letter is "@", the
string is regarded as
(abc@aaa.co.jp is an e-mail address. @aaa.co.jp
is a domain name.)
Touch the [OK] key.
Deleting an anti junk mail/domain name
Touch the [DELETE] key.
The deletion screen will appear.
Touch the address key that you wish to
delete.
A message will appear. Touch the [YES] key to
delete the number.
To cancel the deletion, touch the [NO] key.
(30* )
1 2
ALL INVALID
a domain name.