Print Style Setting; Auto Receive Reduce Setting; Number Of Calls In Auto Reception; Fax Output Tray Setting - Sharp AR-M355N Operation Manual

I I I I Fax receive settings
The fax reception settings allow you to adjust certain
parameters for receiving faxes to better suit your needs.
Settings that can be adjusted depend on the
peripheral devices installed.
The "Fax receive settings" are as follows:
G Auto receive reduce setting
G Number of calls in auto reception
G Duplex reception setting (only when the duplex
module option is installed)
G Print style setting
G Set the telephone number for data forwarding
G Fax output tray setting
G Anti junk fax setting

Auto receive reduce setting

When you receive a fax that includes the sender's
name and number, the received image is slightly larger
than the standard size*. This setting lets you select
whether or not the received image is automatically
reduced before printing to fit the standard size.
Normally automatic reduction is turned on.
NOTE
If auto receive reduce is disabled, an image larger
than the standard size will be cut off. However, the
image is clearer because it is printed at the same
size as the original.
* Standard sizes are sizes such as 8-1/2"x11" and
8-1/2"x5-1/2" (A4 and B5).

Number of calls in auto reception

This setting is used to select the number of rings on
which the machine automatically receives a call
and begins fax reception when the reception mode
is set to auto. (See "RECEIVING A FAX" on page
2-10.) You can select a number of rings from 0 to
15. Normally "2" is selected.
NOTE
If you select "0" for the number of rings, the machine
will immediately answer and begin fax reception
without ringing in auto reception mode.
However, do not select "0" when an extension phone
is connected to the machine.
When "0" is selected, the extension phone cannot be
used to make a call.
Duplex reception setting
(only when the duplex module option is installed)
You can use this setting to select whether received
documents are printed on both sides of the paper.
Normally this setting is turned off. If turned on,
received documents will be printed on both sides of
the paper whenever the received document
consists of two or more pages of the same paper
size.
KEY OPERATOR PROGRAMS

Print style setting

This setting determines the selection condition for
paper when printing received documents. Select
one of the three conditions below. AUTO SIZE
SELECT is normally selected.
G PRINT ACTUAL SIZE CUT OFF DISABLED
The received fax image is printed at its actual
size (without dividing it onto multiple sheets of
paper). If the same size of paper or larger paper
is not loaded, the fax will be received in memory
and will not be printed until a suitable size of
paper is loaded.
G PRINT ACTUAL SIZE CUT OFF ENABLED
Each received image is printed at actual size. If
necessary, the image is split onto multiple
sheets of paper.
G AUTO SIZE SELECT
Each received image is printed at actual size
when possible. When not possible, the image is
automatically reduced before printing.
Set the telephone number for data
forwarding
When a problem prevents the machine from printing
a received fax, the transfer function (page 3-18) can
be used to forward the received fax to another fax
machine. Use this setting to program the fax number
of the destination fax machine. Only one fax number
can be programmed (maximum of 64 digits).
If you wish to specify an F-code confidential memory
box in the destination machine, touch the [SUB
ADDRESS] key after entering the fax number to enter
a slash "/", and then enter the sub-address. Enter a
passcode as well if needed. (See steps 9 to 12 of
"STORING ONE-TOUCH DIAL KEYS" on page 6-3
to 6-4.)

Fax output tray setting

This setting is used to select the output tray for
received faxes. The trays that can be selected will
vary depending on what peripheral devices have
been installed.
8
8-9