Sharp MX-M350U Operation Manual page 30

DESTINATION INPUT METHODS
Touch the desired destination key.
6
tanaka
tanaka a tana
tanaka b tana
tanaka c
tana
destination to the address book by touching the
[REGISTER] key.
7 Select the destination type.
TO CC
tanaka
tanaka a tana
tanaka b
tana
NOTE
BCC can only be selected when the [ENABLE BCC]
checkbox is selected in [BCC SETTING] in the
administrator settings.
8 If you wish to enter another address,
repeat steps 6 and 7.
Multiple destinations cannot be selected for Scan
to FTP, Scan to Desktop, or Scan to Network
Folder.
9 Touch the [CONDITION SETTINGS] key.
CONDITION
SETTINGS
DETAIL
ADDRESS REVIEW
aaa.c
SEARCH AGAIN
aaa.c
■ Address
review
transmission
1 Touch the [ADDRESS REVIEW] key and
check the destinations.
SCAN
ADDRESS BOOK
MODE SWITCH
ADDRESS REVIEW
SPECIAL MODES
FILE
ADDRESS ENTRY
SEND SETTINGS QUICK FILE
To display the remaining
destinations, touch the
[ ] key.
For detailed information
on the selected
destination, touch the
[DETAIL] key. You can
also register the
Normally touch the [TO]
key. However, if you are
performing a broadcast
transmission and wish to
"CC" or "BCC" the
document to the entered
address, touch the [CC]
or [BCC] key.
You will return to the
condition setting screen.
for broadcast
When the [ADDRESS
REVIEW] key is
touched, only the
entered destinations are
displayed. You can also
display the CC and BCC
destinations by touching
the relevant keys.
2-13
If you need to clear a destination, touch its key.
Touch the [OK] key to return to the initial screen.
NOTE
When you perform a broadcast transmission, the
compression mode set with the administrator
setting, "Compression mode at broadcasting"
8-5), is used as the file compression mode for all
destinations.The default setting is "MH (G3)".
■ Checking a broadcast transmission
job result and retransmitting an
error job
The results of a broadcast transmission can be
viewed in the following screen, which is opened by
touching the [BROADCAST XXXX] key (where
"XXXX" is the number of the job; see "NOTES" on
page 2-5) in the finished job screen and then the
[DETAIL] key.
DETAIL OF
BROADCAST XXXX
START TIME
ADDRESS
HQ ADMIN. DEPT.
002 10:01 11/01
SENDAI BRANCH 10:10 11/01
010
FILE
A
A [FILE] tab
This tab is displayed only if the job is stored with the
filing function. If the job is stored, you can
retransmit the same images without scanning the
originals. To retransmit, switch the screen to the
[FAILED] tab or the [ALL DESTINATIONS] tab.
B [FAILED] tab
Among selected destinations for a broadcast
transmission, the destination name, start time, and
transmission status for error transmission are
displayed. You can perform retransmission for the
destinations for which a transmission error
occurred by touching the [RETRY] key.
C [ALL DESTINATIONS] tab
The destination name, start time, and transmission
status for all selected destinations for a broadcast
transmission are displayed. You can perform
retransmission for all the destinations by touching
the [RETRY] key.
(page
OK
STATUS
RETRY
1/ 1
NG000000
NG000000
FAILED ALL DESTINATIONS
B C