Storing Sender Information - Sharp MX-M350U Operation Manual

The one-touch keys stored in the group are
highlighted. To add another one-touch key to the
group, touch the key to highlight it.
To delete a one-touch key from the group, touch
the key so that it is no longer highlighted.
NOTE
If the assigned three-digit number (see
step 5) is known, you can touch the
and enter the three-digit number using the numeric
keys to add a one-touch key to the group or delete a
one-touch key from the group.
5 Make sure the edited information is
correct, and then touch the [EXIT] key.
DELETE EXIT
NOTE
If you cannot edit or delete a group key
If you attempt to edit or delete a group key in the following situations, a warning message will appear and editing/
deletion will not be possible.
● The one-touch key you wish to change or delete is currently being used for transmission or is used in a currently
stored transmission job.
● The group key is included in a program.
If the key is being used for a current transmission or currently stored transmission, cancel the transmission or wait
until it is completed and then edit or delete the key. If the key is included in a program, delete the key from the
program and then edit or delete the key.

STORING SENDER INFORMATION

Use this procedure to store the sender information (sender name and e-mail address) that is displayed when the
recipient receives your e-mail. Information for up to 999*
from the stored senders using the touch panel of the machine when you send an image
sender appears in the sender column of the recipient's e-mail software program.
If you prefer to store sender information from the Web page, refer to
1 Press the [SYSTEM SETTINGS] key.
2 Touch the [SENDER CONTROL] key.
T
SETTINGS
SENDER CONTROL
NG
ADMINISTRATOR
*1 On the MX-M350N/450N, or on a model with the network expansion kit (with hard drive) installed
*2 Without the network expansion kit (with hard drive)
page 6-2,
(Quick) key
If you wish to change
another group key,
repeat steps 3 through
5.
R
STORING FROM THE OPERATION PANEL
The following steps are for deleting a group key.
Touch the [DELETE] key.
6
EXIT
DELETE
7 Touch the [YES] key.
DELETE THE ADDRESS?
GROUP
NO
(500* ) different senders can be stored. Select a sender
1 2
page 1-10.
3 Touch the [STORE] key.
ER CONTROL
STORE
6-7
If you wish to delete
another group
repeat steps 3, 6, and 7.
YES
(page 2-3). The selected
key,