Transmitting A Large Number Of Pages (Job Build) - Sharp MX-M350U Operation Manual

SPECIAL MODES

TRANSMITTING A LARGE NUMBER OF PAGES (JOB BUILD)

When you need to scan more pages than can be loaded in the automatic document feeder at once, use this function
to scan the pages in sets. The maximum number of pages that can be loaded in the automatic document feeder is
50. The resolution, exposure, and original size settings can be changed each time you place a set of originals in the
document feeder.
Example: Scanning 100 A4 (8-1/2" x 11") size pages
Original
Page 1
50 pages
* Divide the original pages into sets of 50 pages or less, and
scan the sets in order beginning from the set with the first
page (first A then B in the above example).
Switch to the desired mode, touch the
1
[SPECIAL MODES] key, and then touch the
key.
ADDRESS REVIEW
SPECIAL MODES
FILE
ENTRY
TTINGS QUICK FILE
Touch the [JOB BUILD] key.
2
SPECIAL MODES
JOB
FAX OW
BUILD
MEMORY BOX
3 Touch the [OK] key.
RESEND
SPEAKER
OK
POLLING
4 Place the original in the automatic
document feeder.
Page 51
50 pages
If the address book screen
appears, touch the
[CONDITION SETTINGS]
key to display the
condition settings screen
(page 1-13).
The [JOB BUILD] key is
highlighted.
To cancel the selection,
SE
touch the key once again
so that it is not
highlighted.
You will return to the
screen of step 1.
Perform the send procedure as explained
5
in "SENDING AN IMAGE".
●In scan mode, perform the procedure in
"SENDING AN IMAGE IN SCAN MODE"
through step 22
●In Internet fax mode, perform the procedure in
"SENDING A FAX IN INTERNET FAX MODE"
through step 18
Press the [START] key.
6
7 Place the next set of pages in the automatic
document feeder.
Press the [START] key. (See step 6.)
8
9 Repeat steps 7 and 8 until all pages have
been scanned, and then touch the [READ-
END] key.
3-10
(page 2-2).
(page 2-6).
The pages are scanned.
When scanning
finished, the [READ-
END] key appears in the
touch panel.
is