Sharp MX-M350U Operation Manual page 26

SENDING AN IMAGE
20
If you have another page to scan, change
pages and then press the [START] key.
Repeat this sequence until all pages have been
scanned. You can change the resolution and
exposure settings as needed for each page (refer
to page 2-18).
If no action is taken for one minute, scanning
automatically ends and the transmission job is stored.
NOTES
● Cancelling transmission
To cancel transmission while the [SCANNING ORIGINAL...] appears in the display or before the [READ-END] key is touched,
press the [C] key or the [CA] key. To cancel a transmission job that is already stored, press the [JOB STATUS] key and cancel
the job as explained on page
● Internet fax settings such as send confirmation, image rotation, and attachment size limit settings can be configured in "I-Fax
send settings" (page 8-7) in the administrator settings.
● If the power is turned off or a power failure occurs while a document is being scanned in the automatic document feeder, the
machine will stop and a document misfeed will occur. After the power is restored, remove the document as explained on page
2-20 of the operation manual (for general information and copier operation).
● A job number appears in the display with "JOB STORED." when a transmission job is stored. If you make a note of this
number, you can use the number to easily locate the job when checking the results of the transmission in the job status screen
for a broadcast transmission
3-13.
(page 2-13), or in the transaction report or activity report.
2-9
21
After the final page is scanned, touch the
[READ-END] key.
GINAL. Pg.No.2
PRESS [READ-END].
READ-END
destination is automatically called and the
document transmitted after previously stored jobs
are completed.) Open the document glass cover
and remove the document.
The machine makes a
beep sound to inform
you that the
transmission job is
stored and the [JOB
STORED] appears in the
message display. (The