Erasing Edge Shadows (Erase) - Sharp MX-M350U Operation Manual

SPECIAL MODES

ERASING EDGE SHADOWS (ERASE)

The erase function is used to erase the shadow lines on images produced when scanning thick originals or books.
The erase modes that can be selected are shown below. The erase width is approximately 10 mm (1/2") in its initial
setting.
Your machine
■ USING ERASE
1 Switch to the desired mode and touch the
[SPECIAL MODES] key.
ADDRESS REVIEW
SPECIAL MODES
ENTRY FILE
TTINGS
QUICK FILE
2 Touch the [ERASE] key.
ERASE
AM
R
2in1
3 Select the desired erase mode.
ERASE
EDGE CENTRE EDGE+CENTRE
ERASE
ERASE ERASE
EDGE ERASE
Erases shadows at edges
that appear when scanning
thick originals or books.
Transmission to
CENTRE ERASE
other machine
Eliminates shadow lines
produced by the bindings
of bound documents.
EDGE + CENTRE ERASE
Eliminates shadow lines around
the edges of images and
eliminates the shadow at the
centre of images.
If the address book screen
appears, touch the
[CONDITION SETTINGS]
key to display the
condition settings screen
(page 1-13).
CA
Select one of the three
erase modes. The
selected key will be
highlighted.
The other machine
Using edge erase
Combining "edge erase"
with "dual page scan" on
the following page
4 If desired, set the width of the edge to be
erased (touch the
set the width).
CENTRE
(0 20)
10
mm
5 Touch the outer [OK] key.
OK
CANCEL
OK
6 Perform the send procedure as explained
in "SENDING AN IMAGE".
●For scan mode, see
●For Internet fax mode, see
NOTE
To cancel the erase function, touch the [CANCEL]
key on the erase setting screen. (step 4)
3-4
key or the key to
The erase width can be
set from 0 mm (0") to
20 mm (1") in 1 mm (1/8")
increments.
You will return to the
screen of step 1 and an
erase icon will appear
next to the
[EXPOSURE] key.
To cancel erase, touch
the [CANCEL] key.
page 2-2.
page 2-6.