Sending A Fax In Internet Fax Mode - Sharp MX-M350U Operation Manual

SENDING A FAX IN INTERNET FAX MODE

NOTES
● Image rotation
A4, B5R, and A5R (8-1/2" x 11" and 5-1/2" x 8-1/2"R) originals are rotated 90 degrees and transmitted in A4R, B5, or A5 (8-
1/2" x 11"R or 5-1/2" x 8-1/2") orientation. (A4R, B5, and A5 (8-1/2" x 11"R and 5-1/2" x 8-1/2") originals cannot be rotated
for transmission.)
● Originals cannot be scanned in succession from both the automatic document feeder and the document glass and sent in
a single transmission.
● The "Rotation sending setting"
before transmission.
The default setting is: rotate A4 to A4R, B5R to B5, and A5R to A5 (8-1/2" x 11" to 8-1/2" x 11"R, and 5-1/2" x 8-1/2"R to 5-
1/2" x 8-1/2").
Make sure that the machine is in image
1
send mode.
FILING
DATA
LINE
IMAGE SEND
DATA
COPY
SYSTEM
JOB STATUS SETTING
SWITCH] key.
2 Load the original.
NOTE
You cannot load documents in both the automatic
document feeder and on the document glass and
send them in a single transmission.
(page 8-7) in the administrator settings can be used to rotate a scanned image 90 degrees
When the [IMAGE
SEND] key light is on,
the machine is in
scanner mode. If the
light is not on, press the
[IMAGE SEND] key.
Select Internet fax mode
with the [MODE
For detailed information
on loading an original,
refer to page 4-3 of the
operation manual (for
general information and
copier operation).
2-6
Transmission
Transmission
Check the original size.
3
STANDARD
RESOLUTION
AUTO A4
ORIGINAL
NOTES
● To scan a two-sided original, refer to
● To rotate the document image 90° before
transmission, see page
4 If needed, adjust the resolution setting.
(Refer to page 2-18.)
STANDARD
RESOLUTION
AUTO A4
ORIGINAL
5 If needed, adjust the exposure setting.
(Refer to page 2-18.)
AUTO
EXPOS
STANDARD
RESOLUTION
AUTO A4
ORIGINAL
SENDING AN IMAGE
The original size is
automatically detected.
If you loaded a non-
standard size document
or wish to change the
scanning size, touch the
[ORIGINAL] key and set
the document size.
(Refer to page 2-15.)
page 2-14.
2-15.
The initial factory setting
is "STANDARD".
The initial factory setting
is "AUTO".