Transmitting Metadata - Sharp MX-M350U Operation Manual

TRANSMITTING METADATA

Follow the steps below to select a metadata set, enter each item, and perform metadata transmission.
1 Touch the [DATA ENTRY] key.
SCAN
ADDRE
MODE SWITCH
DATA ENTRY
ADDRESS
SPECIA
ADDRESS ENTRY
NOTE
If no metadata sets have been stored, the [DATA
ENTRY] key cannot be selected. Store a metadata
set in the Web pages and then perform the
transmission procedure.
2 Touch the key of the metadata that you
wish to use.
CANCEL
OK
METADATA 2
METADATA 4
METADATA 6
METADATA 8
3 Touch the [OK] key.
CANCEL
OK
1/2
ADATA 2
ADATA 4
ADATA 6
ADATA 8
4 The keys of the items stored in the
metadata set will appear. Touch the key of
the item that you wish to enter.
READY TO SEND
.
(METADATA SEND MODE)
METADATA SET
DATA ENTRY
User ID
Pass Code
Bill Code
NOTE
If you selected the wrong metadata set, touch the
[METADATA SET] key and return to the screen of
step 3. Metadata items entered to that point will not
longer be effective.
FI
1/2
5 Touch the key of the value that you wish to
enter.
CANCEL
3 6 DIRECT ENTRY
Value2
Value4
Value6
● If the entry values of the metadata item were stored
in selection format, the selections will appear as
keys. If a value is editable, the [DIRECT ENTRY]
key can be touched to manually enter a value.
● If a metadata item requires the entry of text, a text
entry screen will appear. Enter the required
information.
NOTES
● To change the number of items that appear at
once, touch the display item number select key.
Each time the key is touched, the number of items
displayed switches between 3 and 6.
● For information on entering text, see page 7-29 of
the operation manual (for general information and
copier operation).
6 Touch the [OK] key.
CANCEL
3 6 DIRECT ENTRY
Value2
Value4
Value6
Enter all items.
7
READY TO SEND
.
(METADATA SEND MODE)
DATA ENTRY
User ID Value2
Pass Code xxxxxx
Bill Code xxxxxx
5-4
OK
1/9
OK
1/9
METADATA SET