Faxing A Large Number Of Pages (Job Build Mode) - Sharp AR-M355N Operation Manual

FAXING A LARGE NUMBER OF
PAGES (JOB BUILD MODE)
The maximum number of pages that can be loaded in the automatic document feeder is 50. When you need to fax
more pages than can be loaded in the automatic document feeder, use Job Build mode. This function allows you to
scan the pages in sets.
If the memory becomes full while scanning the pages, a message will appear. To cancel the transmission, touch
[CANCEL]. To transmit only the pages that have been scanned, touch [SEND].
Example: Scanning 100 8-1/2" x 11" (A4) size pages
Original
Page 1
50 pages
* Divide the original pages into sets of 50 pages or less, and
scan the sets in order beginning from the set with the first
page (first A then B in the above example).
In fax mode, touch the [SPECIAL MODES]
1
key and then touch the
MODE SWITCH
ADDRESS REVIEW
SPECIAL MODES
SUB ADDRESS
FILE
TO RECEPTION
QUICK FILE
MEMORY:100%
Touch the [JOB BUILD] key.
2
SPECIAL MODES
FAX O
JOB
BUILD
MEMORY BOX
3 Touch the [OK] key.
SPEAKER RESEND
OK
DUAL PAGE
SCAN
Place the original in the automatic
4
document feeder. (See page 1-7.)
3-10
Page 51
50 pages
key.
If the address book screen
appears, touch the
[CONDITION SETTINGS]
key to display the
condition settings screen
(page 1-5).
The [JOB BUILD] key is
highlighted.
To cancel the selection,
SE
touch the key once
again so that it is not
highlighted.
You will return to the
screen of step 1.
Follow steps 4 through 7 of "BASIC
5
PROCEDURE FOR SENDING FAXES".
(See pages 2-2 to 2-3.)
6 Press the [START] key.
7 Place the next set of pages in the automatic
document feeder. (See page 1-7.)
Press the [START] key. (See step 6.)
8
9 Repeat steps 7 and 8 until all pages have
been scanned, and then touch the [READ-
END] key.
The pages are scanned.
When scanning is
finished, the [READ-
END] key appears in the
touch panel.