Table of Contents
Advertisement
The lower limit can be 0 or a value from 256 through
the upper limit you specify.
If the value in this field is different from the RU size
defined for the remote node, the size used for a session
with that node can be negotiated to establish an
appropriate RU size for the session. The actual value
cannot be lower than the lower limit field.
These numbers, together with the send and receive
pacing values, can be used to tune the session-level
throughput between the local and partner LUs. If you
do not know what values to use, start with the default
values and adjust them as needed to maximize
throughput.
Reset to SNA defined values
If you are modifying a standard mode using the Motif
dialog, you can click on this button to reset the values
of the mode parameters to the SNA-defined values.
Additional Configuration
After performing the mode configuration, continue with the following
configuration tasks:
• To define CPI-C side information, see "Defining CPI-C Side
Information".
• To define APPC security, see "Configuring APPC Security".
• To configure 5250 communication, see Chapter 8, "Configuring User
Applications."
Chapter 7
Configuring APPC Communication
Defining Modes and Classes of Service
199
Advertisement
Table of Contents
