Table of Contents
Advertisement
Configuring APPC Communication
Defining Remote Nodes
defined a remote node and SNAplus2 establishes CP-CP sessions with it,
the entry is temporarily converted into a dynamic one. You should correct
the fault by deleting the remote node definition when the node is
inactive.
To configure a remote node, use one of the following methods:
Motif administration program
Select APPC and New remote node from the
Services menu on the Node window.
Command-line administration program
To define a remote node, issue the following command:
define_directory_entry
To define a partner LU, issue the following command:
define_partner_lu
Remote Node Configuration Parameters
The following parameter is required for remote node configuration:
Node's SNA network name
The fully qualified CP name of the remote node. The
value entered on this dialog must match the CP name
configured at that remote node.
Additional Configuration
After performing the remote node configuration, continue with the
following configuration tasks:
• To define a partner LU, see "Defining Partner LUs".
• To define an invokable TP, see "Defining TPs".
• To define a mode, see "Defining Modes and Classes of Service".
• To define CPI-C side information, see "Defining CPI-C Side
Information".
• To define APPC security, see "Configuring APPC Security".
• To configure 5250 communication, see "Configuring User
Applications".
182
Chapter 7
Advertisement
Table of Contents
