Table of Contents
Advertisement
Configuring Dependent LUs
Defining LU Types 0–3
The link station that provides the link to the host. The
LU definition belongs to the link station you select. (If
the dependent LU resides on a node that supports
DLUR, this field identifies the DLUR PU that provides
connectivity to the host.)
LU numbers
An LU number or range of LU numbers. LU numbers
can be from 1–255.
The LU numbers must correspond to those in the host
VTAM configuration. If you do not know what numbers
are configured on the host, consult your SNA network
planner.
LU type
One of the following LU types (depending on the type of
LU you are configuring):
• For a 3270 display LU, specify the appropriate
• For a printer LU, specify one of the following:
• For an RJE workstation, specify RJE
• If you do not know the LU type, if the LU is used to
The LU type should match the configuration of the LU
at the host. If the host is using DDDLU, the LU may
not be configured at the host. In this case, the LU type
you specify here is used to define the LU on the host
dynamically. Otherwise, the LU type configured at the
host takes precedence.
LU in pool
170
model based on the screen size:
• 3270 model 2 (80x24)
• 3270 model 3 (80x32)
• 3270 model 4 (80x43)
• 3270 model 5 (132x27)
• 3270 printer
• SCS printer
Workstation.
support PU concentration from the local node to the
host (an upstream LU), or if the LU is for an LUA
application, specify Unrestricted (unknown for
command-line configuration).
Chapter 6
Advertisement
Table of Contents
