Table of Contents
Advertisement
Command-line administration program
Issue the following command:
define_local_lu
You can use the advanced dialog to specify sync point support, attach
routing characteristics, restrictions on SSCP access, and security.
Local LU Configuration Parameters
The following parameters are required for local LU configuration:
LU name
The LU name of the local LU.
If you do not know what name to use, consult your SNA
network planner.
This LU name is the second part of the fully qualified
LU name of the local LU. The first part of the fully
qualified LU name (the network name) is always the
same as the first part of the CP name of the local node.
LU alias
The LU alias of the LU. If you do not enter an alias, the
LU name is used as the alias.
Host LS/DLUR PU
The name of the host link station or DLUR PU to which
the LU belongs. (This field applies only if the LU is a
dependent LU.)
LU number
The LU number of the dependent LU. (This field
applies only if the LU is a dependent LU.)
Member of default pool
Whether to make the LU a member of the default
dependent APPC LU pool. An application that does not
specify a particular local LU to use is assigned an
available LU from the default pool.
This field applies only if the LU is a dependent LU.
Additional Configuration
After performing the local LU configuration, continue with the following
configuration tasks:
Chapter 7
Configuring APPC Communication
Defining Local LUs
179
Advertisement
Table of Contents
