Table of Contents
Advertisement
Specify this option to use a member of the default pool
(if one exists) or the node control point LU (if no default
pool is defined).
If the APPCLLU environment variable is set, the local
LU information you supply is ignored, and the LU
specified for the environment variable is used instead.
Partner LU
Either an alias or the fully qualified partner LU name
for conversations initiated by local TPs using this side
information. The partner LU must be an LU that is
configured on the computer that runs the partner TP.
Mode
The name of the APPC mode that is to be used to access
the partner LU. In most cases, the mode is one of the
following predefined modes:
• A blank name
• #BATCH
• #BATCHSC
• #INTER
• #INTERSC
• QPCSUPP
Partner TP
The name of the transaction program with which the
CPI-C application communicates:
• If the TP is a user application, specify the name as
• If the TP is a service TP, specify the name in
The application developer (or for a third-party
application, the product documentation) can provide
this information.
Security
The level of conversation-level security you want to
use. The options are as follows:
None
The partner TP does not require security parameters to
be checked.
Chapter 7
normal characters (up to 64 characters in length).
hexadecimal (up to 8 hexadecimal digits,
representing 4 bytes).
Configuring APPC Communication
Defining CPI-C Side Information
201
Advertisement
Table of Contents
