Table of Contents
Advertisement
Administering SNAplus2
Overview
Overview
The first step in administering SNAplus2 is configuring the node and its
resources. Begin by planning for configuration as described in "Planning
for SNAplus2 Configuration".
Before you can configure SNAplus2, you must enable the SNAplus2
software as described in "Enabling and Disabling SNAplus2 on the Local
System".
When SNAplus2 is enabled, you can run the Motif administration
program (see "Using the Motif Administration Program"). The Motif
administration program guides you through the configuration needed to
support SNA communication using SNAplus2. The Motif administration
program is the recommended administration tool, because it minimizes
the configuration information you need to provide and guides you
through each step you must perform to support different types of
communication (such as 3270 or APPC communication). Alternatively,
you can use the command-line administration program as described in
"Using the Command-Line Administration Program".
For each administration task, this guide provides information you can
use for either Motif or command-line administration. Other
configuration methods are discussed in "Administration Tools".
108
Chapter 3
Advertisement
Table of Contents
