Table of Contents
Advertisement
Configuring an Invokable TP Using snaptpinstall
File Format for snaptpinstall
on the RECEIVE_ALLOCATE verb when it starts up,
to enable SNAplus2 to route the incoming Attach to the
correct TP.
This name must be enclosed within square brackets.
The name can be specified as an ASCII string, enclosed
in double quotation marks (for example,
["TPNAME1"]). Alternatively, it can be specified as a
hexadecimal array representing the EBCDIC
characters of the TP name (for example,
[<53504E414D45F1>]) or as a combination of the two
(for example, [<3f>"TP1"]). In this example, the first
character is the unprintable character 0x3f, and the
following characters are "TP1".
SNAplus2 converts a supplied ASCII string to
EBCDIC, but does not perform any conversion on a
hexadecimal string (which is assumed to be in EBCDIC
already). It then pads the name with EBCDIC spaces
on the right (to a total of 64 characters) before
matching against the specified TP name.
PATH
The path and file name of the executable file for this
TP. If you specify a file name with no path, SNAplus2
uses the normal Windows mechanisms for locating the
executable file.
This line is optional. If it is not included, SNAplus2
assumes that the executable file name is the same as
the TP name, and uses the normal Windows
mechanisms for locating the executable file.
ARGUMENTS
Any command-line arguments to be passed to the TP,
separated by spaces. These arguments are passed to
the TP in the same order as they appear on the
command line.
This line is optional. If it is not included, the TP is
invoked without any command-line arguments.
TYPE
Specify one of the following values:
QUEUED
346
Appendix C
Advertisement
Table of Contents
