Extron electronics FOX Matrix 3200 User Manual page 91

Serial-port-connected firmware upload
Figure 40. Extron Firmware Loader Window
1. Select the FOX matrix switcher and click
. The Choose Firmware File dialog box appears (see figure 41).
Devices
Figure 41. Choose Firmware File Window
2. Navigate to and select the new firmware file. Click
window closes.
3. In the Firmware Loader window, click
The Total Progress and Progress status bars show the upload progress. The firmware
upload may take several minutes. Once the status bars have progressed from
, and Status is listed as
100%
Figure 42. Firmware Loader Screen
4. Click to close the Firmware Loader.
Exit
NOTE: The firmware loader increases the baud rate to 115,200. The
firmware loader may not return the serial port to its earlier baud rate, making
communications with the switcher impossible. If you cannot communicate with the
switcher after a firmware upload, change the baud rate on your computer and, if
necessary, see Selecting the Rear Panel Remote Port Protocol and Baud
on page 42.
Rate
1
>
File New Firmware for Selected
2
2
Open
(see figure 42).
Begin
, the firmware loader utility resets the switcher.
Complete
FOX Matrix 3200 and 7200 Switchers • Matrix Software
. The Choose Firmware File
to
0%
3
83