Site-Specific Option Number Setting; The View Administrative Option - Avaya one-X 9600 Series Installation And Maintenance Manual

Site-Specific Option Number Setting

!
CAUTION:
Do not perform this procedure if you are using static addressing. Perform this
CAUTION:
procedure only if you are using DHCP and the LAN administrator instructs you to
do this.
Use the following procedure to set the Site-Specific Option Number (SSON).
1. When you select SSON... from the Admin Procedures Screen, the following text displays:
Setting:
where the setting is the current system value of DHCP_SSON.
2. To change the setting, press the appropriate softkey(s) and use the dialpad to enter a valid
SSON value between 128 and 255.
3. Press Save to store the new setting and redisplay the Admin Procedures screen.

The View Administrative Option

If you are using static addressing and encounter problems, use the following procedure to verify
the current values of system parameters and file versions.
Note:
Unless otherwise prevented using administration, the user can view but not
Note:
change most of the parameters associated with Craft Local Procedures. For
more information about this option, see the applicable user guide(s).
Note:
If the View Network Information option is not available due to being disabled by
Note:
administration, use the ADDR option to view IP Addresses. See
Addressing Installation
incorrectly. Verify whether you were provided with correct IP Addresses.
on page 36. The IP Addresses might have been entered
Site-Specific Option Number Setting
Static
Issue 3 December 2008 49