Group Identifier; Interface Control - Avaya one-X 9600 Series Installation And Maintenance Manual

3. Press Save to store the new setting.
If the value changed from "On" to "Off", the telephone initiates a reset. If the value changed
from "Off" to "On" the Admin Procedures screen redisplays.
The telephone saves the new value.

Group Identifier

Use the following procedure to set or change the Group Identifier.
Note:
Perform this procedure only if the LAN Administrator instructs you to do so.
Note:
For more information about groups, see
1. When you select GROUP from the Admin Procedures Screen, the following text displays:
Setting:
where the setting is the current system value of GROUP.
2. Enter a valid Group value (0-999).
3. Press Save to store the new setting and redisplay the Admin Procedures screen.

Interface Control

Use the following procedure to set or change the interface control value.
1. When you select INT... from the Admin Procedures Screen, the following text displays with a
prompt to use the Right and Left navigation arrows to select a setting:
Ethernet:
PC Ethernet:
The values shown are the text strings associated with the current PHY1STAT on the
Ethernet line and the current PHY2STAT system value on the PC Ethernet line.
The PHY1STAT text strings are:
"Auto" when PHY1STAT = 1
"10Mbps half" when PHY1STAT = 2
"10Mbps full" when PHY1STAT = 3
The GROUP System Value
Choice Selector
Choice Selector
Issue 3 December 2008
Group Identifier
on page 54.
41