Avaya one-X 9600 Series Installation And Maintenance Manual page 38

Local Administrative Options
3. Depending on the item you selected, choose one of the following:
If you want to
Change any of the IP
Address values (File,
Phone, Router,
Subnet Mask, &/or
DNS Server)
Change the VLAN ID
value
Change the
VLANTEST value
Ping a server (host) to
see if it is reachable/
available
4. Press Save to store the new setting and redisplay the Admin Procedures screen or Cancel
to return to the Admin Procedures screen without saving the value entered. Or, if you sent a
ping to the host server, press OK to return to the Static Address screen.
Once the new values are stored, the telephone is reset.
If a new boot program is downloaded from the HTTP/HTTPS server after you enter static
addressing information, you must reenter your static addressing information.
38 9600 Series SIP IP Telephones Release 2.4 Installation and Maintenance Guide
Then
Use the dialpad to enter the new IP Address. IP Addresses have
three sets of three digits followed by a period. Pressing *
following entry of three digits causes a period to be placed in the
next position, and the cursor to advance one position to the right.
For example, to enter the IP Address 111.222.333.444, press the
1 on the dialpad three times then press *, press the 2 on the
dialpad three times then press *, press the 3 on the dialpad three
times then press *, then press the 4 on the dialpad three times.
Proceed to the next step.
Use the dialpad to enter the new static VLAN ID of from 0 to
4094, inclusive. Proceed to the next step.
Use the dialpad to enter the new value of the DHCPOFFER wait
period of from 0 to 999, inclusive. Proceed to the next step.
Use the dialpad to enter the IP Address or the DNS Name of the
server you want to check. IP Addresses have three sets of three
digits followed by a period. Pressing * following entry of three
digits causes a period to be placed in the next position, and the
cursor to advance one position to the right.
Press the Ping softkey to initiate the check. The telephone
sends four pings and displays the results in a text block screen. If
the ping fails, the message "Unable to contact host" displays.