Assembling The 9600 Series Sip Ip Telephone; Powering The 9600 Series Ip Telephone - Avaya one-X 9600 Series Installation And Maintenance Manual

Table 1: H.323 to SIP and SIP to H.323 Conversion Chart (continued)
To convert this
type of
Environment telephone
H.323-centric SIP

Assembling the 9600 Series SIP IP Telephone

!
CAUTION:
Be careful to use the correct jack when plugging in the telephone. The jacks are
CAUTION:
located on the back of the telephone housing and are flanked by icons to
represent their correct use.

Powering the 9600 Series IP Telephone

All 9600 Series SIP IP Telephones can be locally powered with a Telephone Power Module (DC
power jack), available separately. In addition, the telephones support IEEE 802.3af-standard
LAN-based power. Before installing a 9600 Series IP Telephone, verify with the LAN
administrator whether the LAN supports IEEE 802.3af, and if so, whether the telephone should
be powered locally or by means of the LAN.
Note:
The last step in assembling the 9600 Series SIP IP Telephone must be applying
Note:
power. Apply power either by plugging the power cord into the power source
(local powering) or plugging the modular line cord into the Ethernet wall jack
(IEEE powering).
!
CAUTION:
Failure to connect the proper cables with the proper jacks might result in an
CAUTION:
outage in part of your network.
Assembling the 9600 Series SIP IP Telephone
To this
type of
telephone Then:
H.323 Perform the SIG Craft procedure to change the
SIG parameter value from "2" (SIP) to "default"
(H323). For information, see
Identifier
Save the SIG parameter change. Restart the
telephone as covered in
page 45.
Save the change & restart telephone.
Signaling Protocol
on page 45.
Restart the Telephone
Issue 3 December 2008
on
19