Power-Up Display; Note About The Leds; Input Modes; Figure 3.1 Home Screen Of The Eternus Lt60 S2 - Fujitsu ETERNUS LT40 S2 Installing, Starting Up And Maintaining

Chapter 3 Operating the Tape Library
3.1 Operator Control Panel (OCP)
3.1.2

Power-Up Display

When the ETERNUS LT40 S2/LT60 S2 LTO Library device powers up, or resets, it goes through several internally
controlled processes that allows it to get initialized and running. These processes are called Power-On-Self-
Test (POST). While the POST is happening, the OCP shall have appropriate information displayed to keep the
user informed. When the loader finishes coming alive, it will display the current device status for a defined
time or until a key is pressed.
After this initial status screen the home screen will be shown until a key is pressed. This home screen shows
the overall health of the loader, indicating the status of the robotic and the connected drives.

Figure 3.1 Home screen of the ETERNUS LT60 S2

3.1.3

Note about the LEDs

All LEDs are updated during Power Up and Reset sequences. Upon power up or software Reset, the loader will
illuminate all LEDs as soon as POST allows. This will help the User to verify if all LEDs are functional. When
initialization starts, all LEDs will be extinguished and the Ready/Activity LED will flash at a reasonable rate of
approximately 1-second per cycle, 50% duty cycle. When the mechanical initialization is complete, the Ready/
Activity LED will stop flashing and be constantly illuminated.
If a loader failure occurs, the Ready/Activity LED will be turned off and the Error LED will be illuminated. The
OCP will also display an appropriate error code to help identify the failure.
3.1.4

Input Modes

There are several modes to enter values in the different menu items. These values are: selectable predefined
values, toggle values (e.g. On/Off) and numerical values such as network addresses.
3.1.4.1 Selectable Predefined Values
After navigating to the menu item the various predefined values can be selected with the NEXT and PREVIOUS
button. As soon as the display shows the correct value it may be confirmed by pressing the ENTER button.
FUJITSU Storage ETERNUS LT40 S2/LT60 S2 LTO Library Installing, Starting Up and Maintaining
37
Copyright 2018 FUJITSU LIMITED P3AM-5392-07ENZ0