Connecting The Storage Tray Cables - HP Visualize b132L Owner's Manual

B_configure.doc 132 Thu Jul 11 10:48:31 1996
Storage Tray
Power
Figure 41
Changing Your Workstation's Hardware Configuration
Installing Storage Devices
5 Reconnect the floppy, SE SCSI, power, CD-ROM audio, and FW SCSI cables as
shown in Figure 41.
When connecting the floppy cable to the system board, use the following proce-
dure:
a Lift the locking ring on the connector to the up, or unlocked, position.
b While holding the locking ring in the unlocked position, insert the cable into
the connector until the blue line is even with the locking ring.
c Press down on the locking ring evenly on both ends until it snaps into the
down, or locked, position.
FWSCSI
SESCSI
CD Audio
Floppy Connector

Connecting the Storage Tray Cables

132