Installing The Blade - Roland CAMM-1 PNC-1610 User Manual

6. Installing the Blade

When removing (or changing) the current blade, press the
stop the tool carriage, and then check to make sure the carriage has come to a complete halt
before proceeding.
Depending on the type, the blade may be fitted with a ring to prevent fall-out. If the blade is provided with such as ring, use
procedure B to install the blade.
Inastalling a Blade
Insert a blade into the blade holder until it snaps into
place with an audible click.
Push-pin
Blade holder
Blade
Removing a Blade
Press the push-pin and remove the blade from the
blade holder.
Push-pin
Blade holder
Blade
A
key on the control panel to
Installing a Blade 1
Rotate the tip of the blade holder to remove it.
Installing a Blade 2
Install the blade. Insert the blade fully until it clicks
into place.
Reattach the tip of the blade holder that you re-
moved in the first step ("Installing a Blade 1").
Removing a Blade
Remove the tip of the blade holder (see "Installing
a Blade 1") and press the push-pin to remove the
blade.
8
B