2-7 Downloading Printing/Cutting Date
NOTICE
When printing a line that is horizontal with respect to the direction of material feed, set the line width to 0.15
mm (0.0059 in.) or more. Printing with a line width less than 0.15 mm (0.0059 in.) may cause the ink ribbon to
snap.
The unit will begin printing/cutting when it receives printing/cutting data sent from the computer.
For more details, please refer to the help file for the PC-600 DRIVER or the documentation for the application software you're using.
2-8 Pausing and Stopping Operation
Printing or cutting is
Close the
front cover.
Printing or cutting is
Open the
front cover.
Resumes
The FRONT COVER LED
lights up and printing or
cutting resumes.
Paused
The FRONT COVER LED
flashes and operation pauses.
To Terminate
1) Halt transmission of printing or cutting instructions from
the computer.
2) Hold down the [DATA CLEAR] key until you hear a
beep.
Printing or cutting instructions already sent from the
computer to the PC-600 are deleted, and operation stops.
* After stopping an operation, if the unit does not
function normally when the next batch of data is
sent, switch the power off and back on.
Chapter 2 - Basic Operation
printing or cutting
LED status
Remains continuously
lit during data clear.
Goes dark when data
clear has ended.
35