Downloading Cutting Data; Software Settings; Pausing Cutting Operations - Pause Key, Pause Led And Setup Key - Roland CAMM-1 PNC-950 User Manual

4-7 Downloading Cutting Data

The unit will begin cutting when it receives cutting data sent from the computer.

• Software Settings

When cutting with commercially available application software, select PNC-950 as the setting for the output device. (If
the PNC-950 cannot be selected, choose any model in the PNC-900, PNC-1100, or PNC-1000A).
Select either the parallel (Centronics) or serial (RS-232C) interface. Choose the one that the host computer and the PNC-
950 are connected by.
• Pausing Cutting Operations — PAUSE Key, PAUSE LED, and SETUP Key
If you want to stop the PNC-950 momentarily while it is performing cutting, follow the procedure described below.
Procedure
(1) Press the PAUSE key.
(2)
To Resume Cutting
Press the PAUSE key.
PAUSE
The PAUSE LED goes out and
cutting resumes
* If you want to completely stop the operation of the PNC-950, turn off the power switch.
14
→
PAUSE
↓
The PAUSE LED lights up and cutting is paused
To Terminate Cutting
(2)-1 Halt transmission of cutting instructions from the
computer.
(2)-2 Hold down the SETUP key.
↓
The SETUP LED goes out, cutting instructions already sent from
the computer to the PNC-950 are deleted, the tool carriage moves
to the right, and cutting stops
SETUP