Connecting The Console Terminal To Magnum 6K25E - GarrettCom Magnum 6K25e Installation And User Manual

Magnum 6K25e Gigabit Fiber Switch
the 4 screws and bracket while holding it down firmly.
retaining s crews shown by arrows
Step 3. Remove 6KPM Card
Carefully and gently pull
out the daughter board from the latching
connectors, using both hands, gripping
the board near the latch-up connectors as
shown in Fig. 3.5.3b . If the now empty
slot is to remain unused, be sure to install
a 6KPM-BLNK face plate cover.
Figure 3.5.3b: Removing a 6KPM
Card
If another 6KPM card is replacing the one
that has been removed, follow the steps as described for installing a 6KPM card
discussed in Section 3.5.1.
3.6

Connecting the Console Terminal to Magnum 6K25e

(Management)
Use a DB-9 "null modem" cable to connect the Magnum6K25e Console Port
(the RS-232 port on the 6K25e Switch) to the your PC, so that your PC
becomes the 6K25e's Console Terminal.
Note: The DB-9 cable does not include with the 6K25e unit
package.
Console (DB-9)
Por
t
CONSOLE
PORT
Rear View of Magnum 6K25e, (Typical Console Port is on the Rear of Reverse
6K25e Models)
Note: For detail description of Managed Network Software (MNS-6K) and Magnum
6K25e Switch configuration for Network Management, please refer to Magnum 6K25e
Software Manual available on GarrettCom's FTP site. Detail info. about the MNS is
available on 2.2.9 ( see page no. 13) of this manual.
www GarrettCom com . .
Installation and User Guide (10/07)
Figure 3.5.3a: Top View - 6
36
O
OF