Table of Contents
Advertisement
Magnum 6K32 & 6K32T Managed Switch
Step 3.
Remove 6KPM Card
Carefully and gently pull out the daughter board from the latching connectors, using both
hands, gripping the board near the latch-up connectors as shown in Fig. 3.5.3b . If the
Follow the step 8 to complete the process successfully.
NOTE:1. If the modular slot has not being used and moved to other unit, the empty
slot must be covered with Blank cover, to maintain proper air-inflow inside the unit
and keep off from dust and other unavoidable substance, otherwise can cause a failure
in the Switch.
2. If the PM module in the modular slot is not being installed properly or loose in
connection, the MNS-6K management software will not boot-up properly and a error
will generate as –{ failed to read register device type (offset 0x1600) on slot "A or B or
C or D"}, whichever the slot has been used.
3. Always boot-up the Switch after any new module installation on modular slot to
confirm the successful installation, before placing the chassis cover.
3.6
Connecting the Console Terminal to Magnum 6K32T
(Management)
Use a DB-9 "null modem" cable to connect the Magnum 6K32T Console Port
(the RS-232 port on the 6K32T Switch) to the your PC, so that your PC
becomes the 6K32T's Console Terminal.
Note: The DB-9 cable does not include with the 6K32T unit
package.
Console (DB-9)
Por
t
CONSOLE
PORT
Rear View of Magnum 6K32T
www GarrettCom com
.
.
Installation and User Guide (12/05)
36
now empty slot is
to remain unused,
be sure to install a
6KPM-BLNK face
plate cover.
Figure 3.5.3b:
Removing a
6KPM Card
O
OF
Hide quick links:
Advertisement
Table of Contents
