Camera Directions - BENDIXKing AV8OR User Manual

AV8OR User's Guide
Symbol Type
Red light

Camera Directions

A speed camera can measure the speed of one direction of the
traffic, both directions, or even several directions in an intersection,
when they are mounted on a rotating base. The same directions
apply to red light cameras. Go Drive warns you only if you drive in a
measured or possibly measured direction. The measured direction of
the camera appears with the following symbols:
Symbol
The camera checks the speed of the direction into which
you are driving.
The camera checks the speed of the opposite driving
direction.
The camera checks the speed in both directions on the
road.
Pub. No D200803000008
© Honeywell International Inc. Do not copy without express permission of
Automotive Mode Operation
warns you when you approach one of these
speed cameras, but as you pass by, the
warning stays on, and your average speed
is measured until you reach another speed
camera of this type. If your average speed
exceeds the speed limit between the two
speed cameras, you receive the same
special warning sound as with the other
speed camera types. In the rare case Go
Drive cannot register the moment you pass
the second speed camera (for example, it is
placed at the exit of a tunnel where GPS
position is not yet available) the warning
continues. Just tap the speed camera
symbol displayed on the screen to stop the
warning.
These cameras check if you obey traffic
lights. The warning is similar to mobile
speed cameras: as there is no speed limit
given, only the proximity is announced.
Description
Page 4-33
Honeywell.
Description
Revision July 2008.