Cisco 7960 Administration Manual page 58

Adjusting Placement of the Cisco IP Phone
Use the following procedure to mount the phone on the wall using the standard
footstand. Refer to
Before You Begin
To ensure that the handset attaches securely to a wall-mounted phone, remove the
handset wall hook from the handset rest, rotate the hook 180 degrees, and reinsert
the hook. Turning the hook exposes a lip on which the handset catches when the
phone is vertical. For an illustrated procedure, see Installing the Wall Mount Kit
for the Cisco IP Phone.
Procedure
Push in the footstand adjustment knob.
Step 1
Adjust the footstand so it is flat against the back of the phone.
Step 2
Modify the handset rest so that the handset remains on the ear-piece rest when the
Step 3
phone is vertically placed.
a.
b.
c.
d.
Insert two screws into a wall stud, matching them to the two screw holes on the
Step 4
back of the footstand.
The keyholes fit standard phone jack mounts.
Hang the phone on the wall.
Step 5
Cisco IP Phone Administration Guide for Cisco CallManager 3.2, Cisco IP Phones 7960/7940/7910
3-8
Figure 3-3
Remove the handset from the ear-piece rest.
Locate the tab (handset wall hook) at the base of the ear-piece rest.
Slide this tab out, rotate it 180 degrees (left to right), and reinsert it.
Place the handset on the ear-piece rest.
Chapter 3
for a graphical overview of these procedures.
Installing the Cisco IP Phone
78-10453-04