Cisco 7960 Administration Manual page 138

Resolving Known Issues
Table 7-2 Cisco IP Phone Troubleshooting (continued)
Summary
Moving a network connection from
the phone to a workstation
Changing the telephone
configuration
Phone resetting
LCD display issues
Dual-Tone Multi-Frequency
(DTMF) delay
Cisco IP Phone Administration Guide for Cisco CallManager 3.2, Cisco IP Phones 7960/7940/7910
7-26
Explanation
If you are powering your phone through the network
connection, you must be careful if you decide to unplug the
phone's network connection and plug the cable into a desktop
computer.
The computer's network card cannot receive power
Caution
through the network connection; if power comes
through the connection, the network card can be
destroyed. To prevent this, wait 10 seconds or longer
after unplugging the cable from the phone. This
gives the switch enough time to recognize that there
is no longer a phone on the line, and to stop
providing power to the cable.
By default, the network configuration options are locked to
prevent users from making changes that could impact their
network connectivity. You must unlock the network
configuration options before you can configure them. See the
"Accessing the Network Configuration Settings" section on
page 5-2 for details.
The phone resets when it loses contact with the
Cisco CallManager software. This lost connection can be due to
any network connectivity disruption, including cable breaks,
switch outages, and switch reboots.
If the display appears to have rolling lines or a wavy pattern, it
might be interacting with certain types of older fluorescent
lights in the building. Moving the phone away from the lights,
or replacing the lights, should resolve the problem.
When you are on a call that requires keypad input, if you press
the keys too quickly, some of them might not be recognized.
Chapter 7 Troubleshooting the Cisco IP Phone
78-10453-04