Network Setup Screen - Siemens SISTORE AX9 User Manual

3.10

Network Setup Screen

Siemens Building Technologies
Fire & Security Products
In the Network Setup screen you can set up the DVR for LAN connections.
Fig. 60 Network Setup screen.
Highlight the box beside Connection. Press the
LAN and Modem.
Highlight the box beside Admin Password and press the
keyboard appears. You will first be asked to enter the current password. Then
you can enter a new password; you will be asked to confirm the new password
before it is accepted.
Highlight the box beside User Password and press the
keyboard appears. You will first be asked to enter the current password. Then
you can enter a new password; you will be asked to confirm the new password
before it is accepted.
NOTE:
These passwords are for network use. They are different from the Admin and User passwords for the
DVR itself.
NOTE:
The passwords are case sensitive. The factory default password for both Administrator and User is
12345678.
Write the password down and keep it in a safe place. Once the password has
CAUTION
been reset, the default will no longer work. If the password is forgotten, the unit
must be reset using the Factory Reset Button and all data settings will be lost.
Highlight the box beside Transfer Control. Press the
between On and Off. When On, you can set the transfer speed and remote
quality of the image transferred to a computer running RAS (Remote
Administration System).
Highlight the box beside Transfer Speed and press the
transfer speed from 1 to 25 ips for PAL (1 to 30 ips for NTSC).
NOTE:
When the Record Quality is set to High during the Record Mode setup, the transfer speed can be set
from 1 to 10 ips for PAL (1 to 15 ips for NTSC).
NOTE:
The transfer speed you set is the maximum speed. Depending on the network environment, this
speed may not be achieved.
Configuration
button to toggle between
button. A virtual
button. A virtual
button to toggle
button. Select the
SISTORE AX9 AX16_EN.doc
09.2004
57