Configuring Recording Settings
Record Mode Setup Screen
Siemens Building Technologies
Fire & Security Products
button on the front of the DVR will cause the red LED above the button to light and
indicates the DVR is ready to record. However, this does not mean the DVR is recording. The DVR
records video based on the parameters such as schedule and events defined during configuration.
The red dot appears on the monitor when the DVR is recording.
Your DVR offers a variety of flexible recording modes. You can set it up to record
all the time or to only record events. It can be set up to continue recording once
the hard disk drive is full by recording over the oldest video, or you can set it up to
alert you when the hard disk is full and stop recording.
Record Mode Setup screen.
Highlight the box beside Record Resolution and press the
toggles between Standard and High. When set to Standard, the DVR records
video with the resolution similar to VHS quality. When set to High, the DVR
records video with the resolution similar to DVD quality.
When the Record Resolution is set to High, the recording and playback speed will be decreased in
The Record Resolution will be fixed to Standard when the DVR is in the Quick Setup mode.
Highlight the box beside End Of Disk and press the
between Overwrite and Stop. When in the Overwrite mode, the DVR continues
recording when the hard disk drive is full by overwriting the oldest video. When
in the Stop mode, the DVR stops recording when the hard disk drive is full.
If the DVR is set to the Stop mode, you can set it to beep or activate the Alarm
Out AO1 port when the hard disk drive is full. Highlight the box beside On Disk
Full: Beep and press the
box beside On Disk Full: Alarm Out and press the
On and Off.
button to toggle between On and Off. Highlight the
button. This toggles
button to toggle between
SISTORE AX9 AX16_EN.doc