Menu Preferences - Runco Video Xtreme VX-40d Owner's Operating Manual

Section 3: Operation
Menu Preferences —
SUBMENU
Use the options in this submenu
to adjust the appearance, content
and/or location of on-screen menus
and messages.
LARGE MENU FONT — Enter a
checkmark to enlarge menus and
their text. You may have to adjust "Menu Location" to accommodate the increased menu
area.
MENU LOCATION — Use the pull-down list to choose a pre-defined default or customized
location for the display of all on-screen menus.
To create a custom menu location quickly, choose a preset that is closest to the desired
location. Then adjust "Horizontal Shift" and "Vertical Shift" slidebars to move the menu to
the desired location. Avoid locations too close to a corner or edge to prevent cropping of
larger menus.
HORIZONTAL SHIFT AND VERTICAL SHIFT — Shift your menus as desired, creating
a customized menu location.
DISPLAY CHANNEL LIST — Enter a checkmark if you want to see a scrollable channel
list whenever you press Channel (CHANL) from your presentation. Channels marked with
a list icon in the Channel Setup menu will appear here. The "Display Channel List" option
also enables on-screen feedback when using the Input key. If you prefer to hide the channel
list and input dialog box while switching channels and sources during a presentation, clear
the checkbox.
NOTE: The Channel List and input dialog box cannot be hidden during use of the
menus.
DISPLAY SLIDEBARS — This setting is not applicable to this projector/remote
combination.
DISPLAY ERROR MESSAGES — Choose in what way you want to be notified of errors
detected in either the incoming signal or projector. Select "Screen" or "All" to see a brief
on-screen message or select "RS232" to receive messages via RS232 (or RS422) serial
communication only. Select "Off" to hide error message displays. Because the DHD
Controller uses the RS232 port, Runco recommends this be set to Screen.
Runco VX-40d/-50d/-60d/-80d Owner's Operating Manual
54