Runco Video Xtreme VX-40d Owner's Operating Manual page 84

Section 4: Maintenance
Handle lamp with care. Lamp may explode if dropped.
Wear protective clothing and safety goggles when
Use only Runco approved lamps provided for your projector.
1. Press to power down the projector. Wait at least 5 minutes to allow the internal cooling
fans to stop before unplugging the projector. This wait period is also required to allow the
lamp to sufficiently cool before handling.
Always power down and unplug the projector prior to servicing.
Allow the lamp to cool before handling.
2. Using a screwdriver, loosen the four screws from the lamp door located at the back of
the projector, below the input panel. (Figure 4.2.)
3. Pull (out) and turn the lamp lock lever, which is located to the left of the lamp module, a
quarter turn counter clockwise to the "unlock" position. (Figure 4.3.)
76
WARNING
handling lamps.
WARNING
Figure 4.2. Removing the Lamp Door
Figure 4.3. Unlocking the Lamp
Runco VX-40d/-50d/-60d/-80d Owner's Operating Manual
Lamp door - 4 screws