Connecting Sources - Runco Video Xtreme VX-40d Owner's Operating Manual

Section 2: Installation and Setup
Sources connect to the Input Panel located at the back of the projector. See Figure 2.9.
2.3 Connecting
Sources
The upper right corner (INPUT 1) typically accepts an RGB signal from an external analog
RGB source, or it can also be used for YPbPr signals or additional video sources. The
DVI-I connector (INPUT 2) accepts digital or analog display signals from a computer.
INPUT 3 accepts and analog composite video signal; INPUT 4 an S-Video signal.
(Normally, however, you would connect these types of signals to the DHD Controller.)
There are also several optional interfaces available for connecting other sources. These
interfaces slide into the remaining unused option slot, and can be done while the projector
is running.
From DHD Controller
RGB (BNC)
Figure 2.9 Input Panel
NOTES:
1) Refer to Section 6, Specifications, for details regarding compatible inputs.
2) Use only high-quality, shielded cables for all connections.
INPUT 1 consists of 5 BNC connectors and can be used as the input from the DHD
RGB Signals
Controller. This projector supports multiple sync types with RGB signals: sync-on-green,
composite sync, and separate H and V syncs.
Runco VX-40d/-50d/-60d/-80d Owner's Operating Manual
15