Runco Video Xtreme VX-40d Owner's Operating Manual page 44

Section 3: Operation
What Channels ➤
Are Defined So Far?
All available channels are
listed in the Channel Setup
menu, which describes
how each channel can be
accessed and which serves
as the gateway for editing,
copying and deleting
channels.
From the presentation level, press MENU to display the Main Menu. To display the
Channel Setup menu, press 3 or highlight Channel Setup and press Enter or ►. The
Channel Setup menu appears with the active channel highlighted.
WHAT APPEARS IN CHANNEL SETUP MENU? This menu lists all channels defined so
far and indicates where they are connected on the input panel.
The far left column lists channel numbers currently defined. The
values in the far right columns indicate horizontal and vertical
frequencies—if someone has defined a name for this channel,
it appears here instead. Remaining columns contain details pertaining to each channel
setup, such as its switcher number (always 0 = projector), slot location, a variety of icons
indicating access to each channel, and an abbreviated description of each signal type.
Refer to Editing a Channel Setup for details.
NOTE: If you have more than a handful of channels, use ◄ and ► to see the remaining
channels not visible in the initial display of channels.
SIGNAL TYPE — Either channel list, whether the Channel key list or the Channel Setup
menu, identifies signal types in a shortened form, as shown in Table 3.2. These descriptors
indicate what signal information the projector uses to identify a match for a given channel,
and are preceded by either an "i" (for interlaced signals) or "p" (for progressive signals).
Table 3.2. Signal Type Abbreviations
Abbrev. Signal Type
4WH Composite (4 wire) on HC input
4WV Composite (4 wire) on V input
SG Sync-on-green
5W Separate H,V
5WR Separate H,V swapped
SVid S-Vid
CVid Composite Video
Dig Digital
36
Figure 3.9. Typical Channel Setup Menu
Runco VX-40d/-50d/-60d/-80d Owner's Operating Manual